by the internal counterweight of the instrument. For more details, see the previous chapter on
mounting the IG13 probe.
Once the measuring carriage has been blocked, the mounting of the probe-holder system can
be performed as described on the photo above.
The end of the probe cable must connect directly to one of the USB inputs, behind the panel. It
is not necessary to connect the probe to the first USB port. The three ports can be used without
any distinction.
If you already had an IG13 before purchasing your MICRO-HITE 2016 or MICRO-HITE+M 2016,
it is possible that your accessory cannot be directly connected to the instrument, as the male
connector of your IG13 is different from the female connector of your new height gauge.
Therefore, it is necessary to use an adaptor cable (TESA reference: 00760247).
To Next Page
Loading...
Need help?
General
