Instruction manual for MH & MH+M
157
24 CONTEXT-BASED ACTIONS
Cancel
Allows you to cancel the current process or to leave a mode without saving
any changes.
Delete
Allows you to delete the selected value.
Return
Allow to come back to the previous page
Cartesian coordinates
Allows to work in Cartesian coordinates.
Change angle unit
Allows you to change the unit of the displayed angles. The new unit is
“degree”.
Delete value or letter
Allows you to delete the last character entered when manually entering a
name or a value.
Change angle unit
Allows you to change the unit of the displayed angles. The new unit is
“degree:minute:second”.
Validate
Allows you to validate the current process or to leave a mode while saving
any changes.
Edit
Allows you to edit the name of a selected measurement block in the
memory.
Pause
Allows you to pause the active process
Execution
Allows you to start a measurement process or restart it in case it was
paused before.
Polar coordinates
Allows you to work in polar coordinates.
Change graph
Allows you to change the type of graph displayed when measuring
culmination points.
Change angle unit
Allows you to change the unit of the displayed angles. The new unit is the
“radian”.
Recall
Allows you to recall a file from the USB key.
Cancel last measurement
Allows you to carry out the last measurement in the memory again.
Save
Allows you to save on the USB key.
Zero setting
Allows you to quickly set the selected value to zero.
Ignore
Allows you to avoid certain steps of procedures and to directly access the
result.
Delete block
Allows you to delete the last block of the measurement memory.
Utility services
Access to the menu for maintenance of the height gauge as well as access
to its information.
Update
Starting update of the selected option.
System options
Access to general parameters of the system.
To Next Page
Loading...
Need help?
General
