Instruction manual for MH & MH+M
86
13.3 Reference value
management
In ST1 mode, the reference values are managed the same way as in ST2 mode.
For further details, see this chapter.
13.4 Secondary
functions FX
In ST1 mode, secondary functions are accessible via key .
• Angle measurement (for further details, see this chapter)
• Min, max, Δ (for further details, see this chapter)
• Programs’ management and tolerancing (for further details, see this chapter)
• Delete all measurement blocks and delete reference values in the memory
• Delete one or several measurement blocks
The Min, Max, Δ mode is only active and selectable if the reference
value has already been measured before.
Once the Angle or Min, max, Δ mode selected, it is possible to go
back to ST1 one by pressing the key .
13.5 Context-based
actions
All actions of ST1 mode, displayed and usable from the bar at the back of the screen are
also displayed and usable with ST2 mode. ST2 mode integrates the actions of ST1 mode.
For further details, see this chapter.
To Next Page
Loading...
Need help?
General
