Instruction manual for MH & MH+M
147
Once this page is being displayed, press , select the wanted program from the list and
confirm your selection.
When recalling a program, you will have access to a programs’ list
corresponding to the sequences saved into your USB stick. If you want
to recall a program from ST1 mode, the list will only show programs with
*.st1 format. It is the same recalling a *.st2 sequence from ST2 mode.
Once a sequence has been loaded in memory, it can be either modified or run in loop.
Running a sequence requires blocks in memory. These blocks can either come from a
program that would have been loaded from your USB stick or simply from measurements
performed without any prior saving.
Once you are sure your program in memory is the one you want, press button from panel
keyboard and select the programs management option.
Insert tolerances if needed and start the process pressing .
To Next Page
Loading...
Need help?
General
