TESA MICRO-HITE+M User Manual

Instruction manual for MH & MH+M
67
Lower point
measurement
Rib measurement
Calculation key
Measurement example
Difference
between two
values
Average between
two values (H)
12.6 Manual single
probing (MH)
Manual probing with one hit corresponds to the measurement of a height by establishing
contact between a probe and a flat surface. This process depends on the user, as they
have to move the probe at all times using the handle provided for that purpose.
In noisy environments, the beep tone is often not loud enough to provide
clear information during the measurement. The LED located on the shaft
of the probe support gives you this information visually and close to the
measurement.

TESA MICRO-HITE+M Specifications

General

Brand	TESA
Model	MICRO-HITE+M
Category	Measuring Instruments
Language	English