42
5.2.8. Printing / saving data
Printing and saving is accomplished via the menu Options, which
is accessed via the left function key and is available in many
different menus.
Assignment of the right function key with the function Save or
Print, see Assigning the right hand function key page 49.
Only readings, which have a display field in the
measurement view assigned, will be saved/printed out.
The measurement data can be printed out parallel to the
saving process, while a measurement program is running.
Measure values of diluted sensors (with enabled
measurement range extension) underlined on the printout.
5.2.9. Search for analyzer boxes
(only available via Control unit tab)
> [
] → Search for boxes → [OK].
- Analyzer boxes connected via testo data bus: are displayed
(tabs)
- Analyzer boxes connected via Bluetooth:
• Analyzer box found:
Analyzer box and control unit are connected automatically
• several analyzer boxes found:
The available analyzer boxes are displayed for selection
An existing Bluetooth connection is disconnected by
selecting a new analyzer box from the selection field.
5.2.10. Confirming an error message
If an error occurs, an error message is shown in the display.
> Confirming an error message: [OK].
Errors which have occurred and have not yet been rectified are
indicated by a warning symbol in the status bar.
Not yet rectified error messages can be displayed in the menu
Error diagnosis, see Sensor diagnosis, page 48.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
