57
Activating the function:
> [ ] → Device settings → [OK] → Country Version → [OK]
This action can be password protected. A password is
specified in the menu Password protection, see
Password protection, page 57.
Possibly:
> Enter the password: [Enter] → Enter password → [Next] →
[OK].
Setting the country version:
1. Select the country version: [▲], [▼] → [OK].
2. Confirm confirmation request: Yes → [OK]
- The system is restarted.
If the control unit is connected via Bluetooth to the
measuring box, when the measuring box is restarted, the
control unit should be used to search again for the
measuring box (see
Measure values of diluted sensors (with enabled
measurement range extension) underlined on the pri
Search for analyzer boxes, page 42.)
6.1.2.11. Password protection
This function is available in both the analyzer box and the control
unit. Changes are accepted for the control unit and for the analyzer
box.
The password protection is only valid for functions identified by the
following symbol:
or .
Password protection can be activated / deactivated, the password
can be changed.
To deactivate the password protection change the password to
0000 (factory setting).
Calling up the function:
> [ ] → Instrument Settings → [OK] → Password Protection
→ [OK]
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
