35
2. Press the Control unit against the analyzer box until the locking/
unlocking buttons noticeably clicks into place two times.
To protect the display (i.e. during transport) the control unit
can also be inserted with the back facing up, however, in
this case there is no connection to the analyzer box.
5.2.4.2. Connection using a data bus cable (accessory part to a bus
system)
or
If testo easyEmission software is connected via a control
unit to measuring boxes, the number of measuring boxes
must not be changed. To add new measuring boxes, end
the testo easyEmission software, connect the new
measuring box and restart the testo easyEmission
software.
or
or
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
