67
Parameter Function
Start Determine the start criterion
•
The measuring program is started at any
time (the function key automatically changes
to the stop function).
• Time
Start of measurement at a pre-programmed
time.
• External signal
Trigger signal to control the start of
measuring programs.
Stop Determining the stop criterion
•
The measuring program is stopped at any
time (the function key automatically changes
to the start function)
• Time
The recoding of readings stops at a desired
time.
• External signal
Trigger signal to control the stop of
measuring programs.
• Duration
Setting cycles to save readings.
• Memory full
Saving readings ends when the memory is
full.
Gas time Selection of gas time cycle
Rinse time Enter the rinse time.
The measurement program begins with a
rinse phase (duration: 6min).
Measuring phases (gas time) and rinsing
phases (rinsing time) alternate according
to the programmed values.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
