TESTO 350 - Page 71

71
• Available measuring programs: Flue Gas, Flue Gas + m/s,
Flue Gas + ∆p, Flue gas before + after catalyst, Program for
all analyzer boxes
Engine  >1 and engine <1
• Fuels Natural gas, Butane, Propane, Diesel, Fueloil #5,
Fueloil #6, Kerosene, Anthracite, Bioheat 5, Bioheat 12,
Bioheat 20, Test gas
• Available measuring programs: Flue Gas, Flue Gas + m/s,
Flue Gas + ∆p, Program for all analyzer boxes, Flue Gas
before + after catalyst
• Measuring program Exhaust Gas before + after catalyst: Two
analyzer boxes are required.
If one of the two analyzer boxes is equipped with a
measurement range extension (individual dilution), the testo
350 will automatically recommend this analyzer box to be used
for Before cat.
If the analyzer box used for measurement Before cat is not
equipped with the option measurement range extension, the
device will recommend to install this option.
If the analyzer box used for the measurement Before cat is
equipped with the dilution option and the CO sensor is plugged
into the dilution slot, 5x will automatically be used for dilution. I
a higher dilution factor has already been activated, this setting
will be maintained.
If the analyzer box used for the measurement Before cat is
equipped with the dilution option and the CO sensor is not
plugged into the dilution slot, the device will recommend to
replug the sensor accordingly.
User-defined
• Fuels: Natural gas, Butane, Propane, Diesel, Fueloil #5,
Fueloil #6, Kerosene
, Anthracite, Bituminous, Distillate #1,
Wood 10%M., Wood 20%M., Wood 30%M., Wood 40%M.,
Bark 15%M., Bark 30%M., Bark 45%M., Bark 45%M., Bioheat
5, Bioheat 12, Bioheat 20, Test gas
Activating the function:
1. [
] → Applications → [OK].
Press the function key Options to open configuration
menus.
2. Selecting an application: [ ], [ ] → [OK].
3. Selecting fuel: [
], [ ] → [OK].
w ww . . co m
information@itm.com1.800.561.8187