Redstone™ Optical Spectrum Analyzer Chapter 9: Settings
Page 67 STN053070-D02
Figure 69. Interferogram Processing Settings
9.2.4. Spectrum Settings
In the Spectrum settings tab, it is possible to specify a large number of settings for the processing of the spectra.
Figure 70. Spectrum Processing Settings
• Zero Fill Factor: If not zero, the interferograms will be extended with zeros before the Fourier transform
is applied. A value of one means that the interferogram will be doubled in length and a value of two
means that the interferogram will be quadrupled. This increases the number of data points in the
spectrum and increases the apparent resolution of the spectra.
To Next Page
Loading...
