EasyManua.ls Logo

TOMARK Viper SD-4 RTC - Page 185

TOMARK Viper SD-4 RTC
203 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TOMARK, s.r.o.
Airplane Maintenance Manual
Chapter 90 Emergency Equipment
Issue: 28.FEB 2017 Page 185
Remove launching handle (9) (2 Allen screws).
Remove GRS from the aircraft.
If applicable carry out the following steps:
Reinstall top engine cowling as per Chapter 71-00-01 Top Engine
Cowling.
Reinstall left and right panel as per Chapter 31-00-01 Panel.
Reinstall right control stick as per Chapter 27-00-01 Control Stick.
Reinstall right seat as per Chapter 25-10-01 Seats.
Installation
The following procedure can be dangerous, if the GRS unit and its
functions are not understood. In addition an incorrect reinstallation of
the GRS unit could cause a system failure in an emergency case.
Follow the applicable GALAXY instructions including their “Legal
notice” to ensure safe treatment and a proper installation of the GRS
unit (see Chapter
01-30 Related Publications
). Contact GALAXY
respectively TOMARK in case of any doubt.
DANGER Risk of unintentional rocket firing.
Always contact the manufacturer before performing maintenance on
the GRS unit.
Do not carry out the following procedure in closed halls.
Do not allow anyone to stay in the axis of possible GRS unit fire.
Do not allow anyone to stay in the direction of possible GRS unit
launching direction.
Ensure the launching handle is secured by the peg with the warning
flag during the complete procedure.
Follow the latest edition of applicable GALAXY instructions.
Install in reverse sequence of removal.
Remove safeties A and B as per GALAXY instructions before returning
the aircraft to service.

Table of Contents