Figure 49 above shows the SW environment for entering data for the “IOL Calculation”.
In the “Surgeon” field, you can choose which surgeon will perform the IOL implant and any customization of
the constants or presetting of the preferred lenses and formulae will be applied on this basis.
In “Target” field the target refractive value for the Post-Op must be inserted.
The “Measurements” field summarizes the measurement data.
From the drop-down menu, select the IOL manufacturer and model, as well as the preferred formula with
which to calculate the best lens.
Once this data has been entered, the most appropriate lens can be chosen at the discretion of the surgeon.
The latter is highlighted in orange. Once selected, the lens will be memorized as the preferred one and will
be shown highlighted on the report printout.
Pressing “Reset” will reset the initial preset conditions.
To Next Page
Loading...
