Operation
Topcon HiPer Lite and HiPer Lite+ Operator’s Manual
4-2
Using the MINTER
The MINTER (Figure 4-1) is Topcon’s Minimum INTERface used
to display and control data input and output, and is the same for all
HiPer family receivers.
Figure 4-1. MINTER (HiPer Lite+)
Power Key
Pressing the power key turns the receiver on and off.
Status LED
• When the receiver is on and no satellites are tracked, the
STAT LED will blink red.
• When satellites are tracked, the STAT LED will produce
one blink for each tracked satellite (green for GPS, orange
for GLONASS).
Power Button
Reset
BATT
(battery LED)
RX
(modem status LED)
STAT (status LED)
FN (function/recording button)
REC (recording LED)
To Next Page
