Configuration
Topcon HiPer Lite and HiPer Lite+ Operator’s Manual
2-12
Establishing a Wireless Connection
The HiPer Lite and HiPer Lite+ receivers contain Bluetooth
wireless technology that allows file transfer and
synchronization between the receiver and any other external
device that supports Bluetooth wireless technology; for
example, an IPAQ, or a computer with USB-to-Bluetooth
adapter or PCMCA-to-Bluetooth adapter installed.
NOTICE
NOTICE
Changing the receiver’s Port B default settings will affect
the Bluetooth link. The default settings for Port B are:
115200 bps, 8 data bits, 1 stop bit, no parity, and no
handshaking.
The receiver and external device connection procedure varies
slightly depending on the type of external device used. In
general, the connection procedure is as follows:
NOTICE
NOTICE
Refer to your Bluetooth-enabled external device
documentation for detailed connection information.
1. Turn on a Bluetooth-enabled external device and the
receiver. The default external device mode is Master; the
receiver’s Bluetooth module mode is Slave.
2. Instruct the external device (Master) to search for the
receiver (Slave).
3. Once the Master device detects the receiver, use the
procedure described in the external device’s documentation
to connect it with the receiver.
4. Once connected, continue with Step 1 in “Establishing a
PC-CDU Connection” on page 2-14.
To Next Page
Loading...
