Configuration
Topcon HiPer Lite and HiPer Lite+ Operator’s Manual
2-10
Charging Internal Batteries
Use one of the following conditions for maximum battery
charge speed.
• The receiver is turned off. Power Mode and Charger
Mode are set to Auto. See “Power Management” on
page 2-5 for setting these parameters.
• The receiver is turned on. Power Mode is set to
External and Charger Mode is set to Auto.
1. To charge the internal batteries:
• Plug the receiver-to-SAE power cable into the
receiver’s power input port.
• Connect the receiver-to-SAE power cable and the
power supply-to-outlet cable to the AC adapter.
• Plug the power supply-to-outlet cable into an
available outlet.
2. Press the Reset key on the receiver. This will ensure
that the receiver is in Normal mode for charging. The
receiver will not charge in Zero Power Mode (see “Zero
Power Mode” on page 4-21 for more information).
3. Leave overnight. A nine-hour charge will charge the
batteries about 90%. A ten-hour charge will fully
charge the receiver. The internal batteries cannot be
overcharged.
4. When finished charging, set Power Mode to Auto.
NOTICE
NOTICE
If you remove a power supply cable before setting Power
Mode to Auto, the receiver will be turned off. To turn it on,
you will need to connect an external power supply once
again.
To Next Page
Loading...
