MINTER Configuration
P/N 7010-0557 www.topconpositioning.com
2-25
Recording Interval parameter
This parameter specifies the message output interval into the
log file when the MINTER FN key (pressed for 1–5 seconds)
activates data logging. This setting is used for both logging a
single log file, and logging receiver data in AFRM mode.
Values are 1–86400 seconds.
The default value is one second.
Elevation Mask for Log File parameter
This parameter specifies the minimum elevation angle for the
satellites whose data will be put in the receiver files logged
when pressing FN.
The default value is five degrees.
File Name Prefix parameter
This parameter specifies the prefix added to the names of
receiver files created when pressing FN. The prefix can be up to
20 characters long.
The default value for the Name Prefix is log.
Log file names have the following structure:
<prefix><month><day><sequential alphabet letter>
The file name depends on both the file creation time (month
and day) and additional letter suffixes to avoid confusion
between files created on the same day.
Always Append to the File parameter
If you want new receiver data to be appended to an existing log
file, enter the desired file name in this parameter. The setting
can be up to 20 characters long.
To Next Page
Loading...
