Topcon HiPer Lite - Chapter 2 Configuration

Chapter 2
P/N 7010-0557 www.topconpositioning.com
2-1
Configuration
This chapter describes:
• Receiver’s power supply
• Connecting the receiver and a computer
• Configuring the receiver
• Minimum INTERface (MINTER) configuration
• Radio configuration
• Bluetooth module configuration
• Collecting almanacs
Before you can begin using the HiPer Lite or HiPer Lite+ receiver,
do the following:
1. Charge the batteries. See “Powering the Receiver” on page 2-2.
2. Configure the various parts of your receiver. See:
• “Connecting the Receiver and a Computer” on page 2-11,
• “Receiver Configuration” on page 2-17,
• “MINTER Configuration” on page 2-22,
• “Radio Configuration” on page 2-30 (if applicable), and
• “Bluetooth Module Configuration” on page 2-37.
3. Collect an almanac. See “Collecting Almanacs” on page 2-43.