MINTER Configuration
P/N 7010-0557 www.topconpositioning.com
2-27
turns off. This counter decrements on every file rotation until it
value becomes zero, then file rotation automatically stops. The
counter initializes with AFRM.
Note that a log file opens immediately after turning AFRM on.
This startup file is not considered a file rotation event; the
AFRM counter will not decrement.
Values are 0 to [2
31
-1]. The default value is 0 (zero). Zero
means that an unlimited number of log files will be created.
NOTICE
NOTICE
The receiver’s memory holds up to 512 files.
• Files (remain) – specifies the number of files left for the
receiver to create in AFRM.
Values are 0 to [2
31
-1]. The default value is zero.
• Automatically remove old files – when no free memory is
available to log data, automatically removes the earliest log file.
If this parameter is enabled, your receiver will erase the file
with the earliest file creation time/date. AFRM must be enabled
to use this FIFO (First-In, First-Out) feature.
The default value is off (disabled).
FN Key Mode parameter
Use these two radio buttons to program how the receiver will
react when pressing the FN key.
• LED blink mode switch – pressing FN will toggle between
the MINTER’s normal/extended information modes and
start/stop data recording of Static survey.
– FN pressed for less than 1 second: changes the
information mode (Normal or Extended Information
(EI) Modes).
To Next Page
Loading...
