Operation
Topcon HiPer Lite and HiPer Lite+ Operator’s Manual
4-24
4. Activate FLoader (Figure 4-17).
Figure 4-17. FLoader Main Screen
5. On the Connection tab, select the COM port on your computer
that connects with your receiver and select it’s speed (usually
115200) (Figure 4-17).
See the following sections to load the appropriate firmware.
Receiver and Power Board Firmware
Receiver and power board firmware is released as a compressed
file that you download and decompress. This file contains the
following three files:
• ramimage.ldr – the Receiver board RAM file
• main.ldp – the Receiver board Flash file
• powbrd.ldr – the Power board RAM file
NOTICE
NOTICE
You must load all three files when loading new firmware.
These files must come from the same firmware package.
To Next Page
Loading...
