Powering the Receiver
P/N 7010-0557 www.topconpositioning.com
2-5
Turning On/Off the Receiver
To turn On the receiver, press and hold the green power key for
about 0.5 seconds and release it.
NOTICE
NOTICE
If the receiver does not turn on, it may be in Zero Power
Mode. See “Zero Power Mode” on page 4-21 for more
information.
To turn Off the receiver, press and hold the green power key for
more than one and less than four seconds (until both the STAT
and the REC LEDs are off). This delay (about 1 second) will
prevent the receiver from being turned off by mistake.
Power Management
You can use Topcon’s PC-CDU software to manage your
receiver’s power. The complete description of PC-CDU
exceeds the scope of this manual, but can be found in the
PC-CDU User’s Manual. The latest copy of this software and
the manual can be downloaded from the TPS website.
To access the dialog box controlling the power settings for the
receiver, take the following steps:
1. Connect your receiver and computer. See “Connecting the
Receiver and a Computer” on page 2-11 for this procedure.
2. Once connected, click ConfigurationReceiver
(Figure 2-2).
Figure 2-2. Configure Receiver
To Next Page
Loading...
