Configuration
Topcon HiPer Lite and HiPer Lite+ Operator’s Manual
2-28
– FN pressed for 1 to 5 seconds: starts or stops data
recording (Static post-processing mode).
• Occupation mode switch – pressing FN (less than one
second) will insert into the corresponding log file a
message indicating that the survey type has been changed
from static to kinematic, or vice versa. If the REC LED
blinks green, the current mode is dynamic, if it blinks
orange, the current mode is static. For more details, see
Table 4-1 on page 4-5, and refer to the MINTER User’s
Manual and PC-CDU User’s Manual.
Initial Data Collection Dynamic Mode parameter
These radio buttons specify the starting occupation type
descriptor inserted at the beginning of receiver files logged.
Select Static or Kinematic to specify that the corresponding log
file will start with a static (STOP) or kinematic (GO,
Trajectory) occupation, respectively.
Data Recording Auto-start parameter
These radio buttons allow you to program your receiver’s
behavior in the event of a power failure.
Table 2-2 on page 2-29 gives the different scenarios available
and the results after power is restored to the receiver. “Specified
file” refers to the file name entered in the Always append to file
parameter.
To Next Page
Loading...
