Topcon HiPer Lite - Establishing an RS232 Cable Connection; Establishing a USB Connection

Connecting the Receiver and a Computer
P/N 7010-0557 www.topconpositioning.com
2-13
If you cannot establish a connection, check that the receiver’s
slot three is enabled.
1. Connect your receiver and a computer using an RS232
cable or USB cable and PC-CDU as seen below.
2. Click ConfigurationReceiverGeneral.
3. In the Turn on/off Slots area, ensure the Slot 3 (B) check
box is enabled.
Establishing an RS232 Cable Connection
1. Using the RS232 cable, connect the serial port of your
computer (usually COM1) to the receiver’s serial port A.
2. Press the power buttons on the receiver and computer to
turn them on.
3. Continue with Step 1 in “Establishing a PC-CDU
Connection” on page 2-14.
Establishing a USB Connection
Make sure the computer has the TPS USB driver installed.
1. Using the USB cable and the HiPer Lite+, connect the USB
port of your computer to the receiver’s USB port.
2. Press the power buttons on the receiver and computer to
turn them on.
3. Continue with Step 1 in “Establishing a PC-CDU
Connection” on page 2-14.