- 128 -
Notes (1) Explanation of processes involved to stop the label at the home position after the
head-open state is detected:
When the gap between labels (black mark) is found after the head open state is
detected, the value to stop at the home position of each label between the head
and the sensor is set again.
• The paper is moved in the above state.
• Stop position after feeding one label
* However, an error will result when feed jam conditions are met.
(2) Any cut or strip issue commands should not be sent to the printer on which the
cutter or strip module is not installed.
Sensor
A
B
C
Stop position
Paper feed direction
A
B
C
Stop position Sensor
D
+15 mm after detection
of gap between B and C
A
B
C
Stop position
77 mm
92 mm
Sensor
To Next Page
Loading...
