- 180 -
(3) When the automatic home position detection is set to ON, the media must be set
as follows. Otherwise, the printer cannot detect a home position correctly.
(The printer basically performs the automatic home position detection during the
cut issue.)
(4) When the automatic home position detection is set to ON, the printer operation
differs depending on the printer statuses.
<#1> When the printer power is turned OFF and back to ON or when the top cover is
opened and closed.
1) Set the media so that the 2
nd
black mark is positioned before the print head
position.
2) When the power is turned on or the top cover is closed, the printer feeds the
media in the reverse direction until the black mark sensor detects the 2
nd
black
mark. (If the 2
nd
black mark is not detected while printer feeds a half of the
specified media length, a paper jam error results.)
Print head position
Black mark sensor
(The sensor should be positioned at
the center of the media width.)
1
st
black mark
Set the media so that the 2
nd
black mark is positioned before the
print head position.
Cut position
Cut position
Print head position
Black mark sensor
1
2
Cut position
Print head position
Black mark sensor
1
2
Feed direction
To Next Page
Loading...
