- 165 -
6.3.26 RESET COMMAND [ESC] WR
Function Returns the printer to its initial state.
Format [ESC] WR [LF] [NUL]
Explanation The printer is returned to the same state as when the power was turned on. When the
printer receives this command during printing, it returns to its initial state after issuing
the label which is being printed. The next command must not be sent while the printer
is performing initial processing after this command is transmitted.
Notes (1) The Reset Command is effective in serial interface (RS-232C), parallel port, USB
port or socket communications.
(2) When the printer receives a command in system mode, only the Reset Command
can be processed and any other command cannot be processed.
(3) If a command error or communication error occurs when receiving the Reset
Command, the error message is displayed in the online mode. However, it is not
displayed in system mode.
(4) After the code of the Writable Character Command ([ESC] XD) or Graphic
Command ([ESC] SG) is received, the Reset Command is not processed until the
printer receives the data specified for the type of data.
Example [ESC] WR [LF] [NUL]
To Next Page
Loading...
