Toshiba B-EV4 Series - Feed Speed

- 138 -
(4) Feed speed
• A feed is performed at the designated speed.
However, the back feed speed in the cut mode or the strip mode is 3”/sec.
• The possible issue speed varies according to types and sizes of the paper
supply.
For details, refer to the Supply Specification.
Model
203 dpi model 300 dpi model
Issue mode
Parameter
C: Batch D: Strip E: Strip C: Batch D: Strip
E:
Strip
1
2
2”/sec 2”/sec 2”/sec 2”/sec 2”/sec 2”/sec
3 3”/sec 3”/sec 3”/sec 3”/sec 3”/sec 3”/sec
4 4”/sec 4”/sec 4”/sec
5
6
7
8
9
A
B
5”/sec 5”/sec 5”/sec
4”/sec 4”/sec 4”/sec
Notes (1) If a change of label size or type of sensor, feed fine adjustment, cut position fine
adjustment (or strip position fine adjustment) or back feed fine adjustment is
made, one label must be fed to adjust the first print position prior to printing.
(2) The parameter of the Feed Command is protected in memory (even if the power is
turned off).
(3) When “status response made” is selected in the Issue Command parameter
setting, a status response is made after the end of feed or when an error occurs.
(4) For explanation about the process to stop the label at the home position, refer to
the section regarding the Issue Command.
(5) When “with automatic forward feed standby” is selected by the parameter setting
and if no subsequent command is received from the PC after the last label has
been fed, the printer automatically performs a 16.3-mm forward feed. When the
Feed Command is received during the forward feed standby, the printer feeds the
label in reverse to the original position.
* For notes, refer to the section regarding the Issue Command.