Toshiba B-EV4 Series - LED Indications Table

- 194 -
10. LED INDICATIONS
No.
LED Indication
Printer Status
Restoration by
[FEED] key while
error state
Acceptance of
Status Request
Reset
Green Red Orange
Yes/No Command
Yes/No
1

In the online mode - Yes
★
In the online mode
(Communicating)
- Yes
2
  
The top cover was opened in the online
mode.
- Yes
3
◎
In a pause state Yes Yes
4

A parity error, overrun error or framing
error has occurred during communication
by RS-232C.
Yes Yes
5
★
A paper jam occurred during paper feed. Yes Yes
6
★
An abnormal condition occurred at the
cutter.
Yes Yes
7

The label has run out. Yes Yes
8
◎
A feed or an issue was attempted with the
top cover opened.
(except the [FEED] key)
Yes Yes
9
◎ ◎
The stepping motor temperature has
become excessively high.
No Yes
10
◎ ◎
The thermal head temperature has become
excessively high.
No Yes
11

The ribbon has run out.
An abnormal condition has occurred in the
encoder
Yes Yes
12

The last label has been issued normally
and the label has run out.
Yes Yes
13

In writable character or PC - Yes
command save mode
14

An error has occurred in writing data into
the SD card.
No Yes
15

An erase error has occurred in formatting
SD card.
No Yes
16

Saving failed because of the insufficient
capacity of SD card.
No Yes
17
◎
SD card is being initialized.
(Initialization is carried out for
approximately 15 seconds)
– –
18

An EEPROM for back-up cannot be
read/written properly.
No No