Toshiba B-EV4 Series User Manual

- 2 -
3. INTERFACE
3.1 SERIAL INTERFACE
(1) Type : Conforming to RS-232C
(2) Mode of Communication : Full duplex
(3) Transmission Speed : 2400 bps
4800 bps
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
(4) Synchronization Method : Start-stop synchronization
(5) Start Bit : 1 bit
(6) Stop Bit : 1 bit
2 bits
(7) Data Length : 7 bits
8 bits
(8) Parity : None
Even
Odd
(9) Error Detection : Parity Error Vertical parity error check
Framing Error This error occurs if no stop bit is found in the frame
specified starting with the start bit.
Overrun Error This error occurs if the next data is input before the
data input to the UART from the host is read by the
printer CPU.
(10) Protocol : No-procedure method
(11) Data Input Code : ASCII code
European character set 8 bit code
Graphics 8 bit code
(12) Receive Buffer : 1 M bytes

Toshiba B-EV4 Series Specifications

General

Print Method	Direct Thermal / Thermal Transfer
Power Supply	AC 100-240V, 50/60 Hz
Operating Temperature	5°C to 40°C
Print Resolution	203 dpi, 300 dpi
Max Print Speed	Up to 127 mm/sec (5 ips) (203 dpi) / Up to 101.6 mm/sec (4 ips) (300 dpi)
Interface	USB, Serial
Optional Interfaces	Wireless LAN
Weight	2.4 kg
Barcodes	Code 39, Code 128
2D Codes	Data Matrix, PDF417, QR Code, Maxi Code
Media Width	25.4 mm to 112 mm
Media Thickness	0.06 mm to 0.19 mm
Media Roll Diameter	Max. 127 mm
Ribbon Width	40 mm to 110 mm
Ribbon Length	300 m
Operating Humidity	25% to 85% non-condensing