Toshiba B-EV4 Series - Fine Adjustment Value Set Command

- 179 -
o: [FEED] key function
0: FEED: Feeds one label.
1: PRINT: Prints data from the image buffer on one label.
p: Kanji code selection
0: Ignore
1: Ignore
qq: Euro code setting
“20” to “FF” (Specify the hex code in 2 bytes of ASCII code)
*1
r: Automatic head broken dots check
0: Ignore
1: Ignore
s: Centronics ACK/BUSY timing setting
0: Ignore
1: Ignore
t: Web printer function setting
0: Ignore
1: Ignore
u: Automatic home position detection (Omissible and not initialized by parameter
clearance by key operation)
0: OFF (Default)
1: ON
v: Automatic sensor calibration setting (Omissible and not initialized by parameter
clearance by key operation)
0: OFF (Default)
1: ON with current sensor when power on
w: Printer model setting (Omissible and not initialized by parameter clearance by
key operation)
0: B-EV4D
1: B-EV4T
Explanation (1) This command is not executed until the printer enters an idle state.
(2) The parameters set by this command become effective when the power is turned
on.
*1: Hex codes to be set are expressed in 2 bytes of ASCII code as shown below:
Example 1: To set 36H: ”36” (33H, 36H)
Example 2: To set 42H: ”42” (34H, 32H)
Example 3: To set FFH: ”FF” (46H, 46H)