Toshiba B-EV4 Series - In the Case of Maxicode (Two-Dimensional Code)

- 77 -
~ In the case of MaxiCode (Two-dimensional code)
Format c [ESC] XBaa; bbbb, cccc, d (, e) (, Jffgg) (, Zh) [LF] [NUL]
Term aa: Bar code number
00 to 31
bbbb: Print origin of X-coordinate of the bar code
Fixed as 4 digits (in 0.1 mm units)
cccc: Print origin of Y-coordinate of the bar code
4 or 5 digits (in 0.1 mm units)
d: Type of bar code
Z: MaxiCode (Two-dimensional code)
e: Mode selection (Omissible)
Omitted: Mode 2
0: Mode 0 (Old specification)
1: Mode 1 (Old specification)
2: Mode 2 (New specification)
3: Mode 3 (New specification)
4: Mode 4 (New specification)
5: Mode 2 (New specification)
6: Mode 6 (New specification)
7: Mode 2 (New specification)
8: Mode 2 (New specification)
9: Mode 2 (New specification)
Jffgg: Connection setting (Omissible. No connection if this parameter is omitted.)
(If mode 0 or mode 1 is designated, it is ignored.)
ff: Code number 01 to 08
gg: No. of divided codes 01 to 08
Zh: Attachment of Zipper block and Contrast block (If mode 0 or mode 1 is
designated, it is ignored.)
(Omissible. If omitted, they are not attached.)
h= 0: No attachment of Zipper block and Contrast block
1: Attachment of Zipper block and Contrast block
2: Attachment of Zipper block
3: Attachment of Contrast block