- 191 -
9.1.3 DETAIL STATUS
Detail Status
Printer Status
Auto Status Status Request
Transmission Command
The top cover was closed in the online mode. 00 00
The top cover was opened in the online mode. 01 01
Operating (Analyzing command, drawing, printing, feeding) – 02
In pause – 04
Waiting for stripping – 05
A command error was found in analyzing the command. 06 06
A parity error, overrun error or framing error occurred
during communication by RS-232C
07 07
A paper jam occurred during paper feed. 11 11
An abnormal condition occurred at the cutter. 12 12
The label has run out. 13 13
An attempt was made to feed or issue with the top cover
open.
(except the [FEED] key)
15 15
The stepping motor temperature has become excessively
high.
16 16
The thermal head temperature has become excessively
high.
18 18
The ribbon has run out.
An Abnormal condition has occurred in the encoder
21 21
The last label has been issued normally and the label has
run out.
23 23
A label issue is completed normally. 40 –
The feed has been terminated normally. 41 –
In writable character or – 55
PC command save mode
An error has occurred in writing data into the SD card. 50 50
An erase error has occurred in formatting the SD card. 51 51
Saving failed because of the insufficient capacity of the SD
card.
54 54
The SD card is being initialized. – 55
An EEPROM for back up cannot be read/written properly. 55 55
To Next Page
Loading...
