- 39 -
C (aa): Stroked out character
aa: No. of dots from the character string area to the end of the stroke
aa: 01 to 99 (in units of dots)
* Descriptions in parentheses are omissible.
(If omitted, it is character magnification (the larger one of horizontal or
vertical magnifications) × 6 dots.)
Jkkll: Bold character designation
(Omissible. If omitted, this process is not performed.)
kk: No. of horizontal shift dots
00 to 16 (in dots)
ll: No. of vertical shift dots
00 to 16 (in dots)
Mm: Type of check digits to be attached.
(Omissible. If omitted, this process is not performed)
m: Type of check digit
0: Modulus 10 (Draws data and check digit)
1: Modulus 43 (Draws data and check digit)
2: DBP Modulus 10 (Draws data and check digit)
noooooooooo: Increment and decrement
(Omissible. If omitted, incrementing/decrementing is not performed.)
n: Designates whether to increment or decrement.
+: Increment
-: Decrement
oooooooooo: Skip value
0000000000 to 9999999999
Zpp: Zero suppression
(Omissible. If omitted, the zero suppression process is not performed.)
pp: No. of zeros to be suppressed
00 to 20
Pq: Alignment (Omissible, If omitted, the alignment is set to left.)
q: Designates the character position
1: Left
2: Center
3: Right
4aaaa: Equal space
aaaa: X direction of character string area
203dpi: 0050 to 1040 (in 0.1 mm units)
300dpi: 0050 to 1057 (in 0.1 mm units)
5aaaabbbcc: Automatic line feed
aaaa: Character string area of X direction
0050 to 1040 (in 0.1 mm units)
bbb: Line feed length
010 to 500 (in 1 mm units)
cc: Number of lines
01 to 99
To Next Page
Loading...
