- 130 -
Also, there are a few notes on duplicate printing areas and high power duplicate
printing areas, as follows:
• Areas 1-mm inside of a high power duplicate printing area are printed at the
print density for duplicate printing areas.
• When a specified high power duplicate printing area is exactly the same as a
duplicate printing area, that area will be printed as a high power duplicate
printing area.
• When a high power duplicate printing area is allocated at 1-mm inside of a
duplicate printing area (1 mm from each boundary), the high power duplicate
printing is performed as specified.
(4) Printing is not possible in the areas 1-mm inside of a duplicate printing area.
(5) Note that the actual print density fine adjustment value for high power duplicate
printing is a sum of the values specified by this command and a Print Density Fine
Adjust Command (AY). The maximum value is +10.
Example)
Print Density Fine Adjust Command (AY): +5
Print density fine adjustment value for high power duplicate printing: +5
In the above case, high power duplicate printing areas will be printed at +10 and
the other areas will be at +5, respectively.
(6) On-the-fly issue is available even when a label has both a normal printing area and
a duplicate printing area.
(7) When the issue speed is set to “A” without a duplicate printing area specified, the
printer automatically operates at an issue speed of “B”.
(8) When the issue speed is set to “B” with a duplicate printing area specified, the
printer operates at an issue speed of “B” without performing duplicate printing.
To Next Page
Loading...
