- 152 -
Notes (1) No matter what character set or character code is selected, no memory will be
wasted.
(2) When a new writable character is stored, Flash Memory Format Command ([ESC]
J1) must be transmitted.
(3) A character code already stored can be stored in SD card again if the Writable
Character Command ([ESC] XD) is transmitted, but memory will be consumed
with every storage. Memory can be efficiently used by sending the Format
Command ([ESC] JA) before storing.
(4) If SD card is used, and a label issue operation is performed after sending the Bit
Map Writable Character Command ([ESC] XD), the image buffer is cleared
automatically.
(5) When the storing operation stops after storing the writable character and logos,
the printer automatically enters the online mode (label issue operation) after about
10 seconds. In this case, when the SD card is used, the image buffer will be
cleared automatically.
Refer to Flash Memory Format Command ([ESC] J1)
SD Card Format Command ([ESC] JA)
To Next Page
Loading...
