Toshiba e-STUDIO556 - Page 153

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 7
(5) Take off the top right cove and right upper
cover.
( P.4-2 "4.1.3 Top right cover", P.4-3
"4.1.7 Right upper cover")
(6) Release the harness from the clamp.
(7) Remove 1 screw and take off the clamp.
Fig. 4-18
(8) Remove 4 screws.
(9) Release the harness from the clamp and
then place the control panel unit with its
reverse side up.
Note:
When assembling the unit, be sure that the
harness is not caught.
Fig. 4-19
(10) Remove 1 screw, take off 3 clamps and
disconnect 1 connector (with a lock).
(11) Remove 2 screws, take off a USB port and
then the control panel unit.
Fig. 4-20
[1]