Toshiba e-STUDIO556 - Read Motor (MR2)

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 140
4.12.26 Read motor (MR2)
(3) Remove1 E-ring and 1 bushing.
Fig. 4-397
(4) Disconnect 1 connector.
(5) Remove 3 screws and take off the original
feed motor bracket with the motor.
Note:
When installing the original feed motor
bracket, refix the loosened screw and tighten
the belt tension.
Fig. 4-398
(1) Take off the RADF rear cover.
( P.4-117 "4.12.3 RADF rear cover")
(2) Loosen 1 screw.
Fig. 4-399
Bushing E-ring
Connector