Toshiba e-STUDIO556 - Developer Unit Detection Switch (SW3)

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 83
4.8.20 Developer unit detection switch (SW3)
4.8.21 Toner filter unit / Developer unit fan (M31)
(1) Take off the cleaner unit.
( P.4-61 "4.7.1 Cleaner unit")
(2) Disconnect 1 connector, remove 1 screw and
then take off the sensor bracket.
Fig. 4-234
(3) Disconnect 2 connectors, remove 1 screw
and then take off the developer unit detection
switch.
Fig. 4-235
(1) Take off the right rear cover.
( P.4-4 "4.1.9 Right rear cover")
(2) Pull out the toner filter.
(3) Remove 2 screws to pull out the filter duct.
(4) Disconnect 1 connector of the fan.
Fig. 4-236
Sensor bracket
Screw
Developer unit detection switch
Connector
Screw
Toner filter
Filter duct