Toshiba e-STUDIO556 - Others

8
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
ERROR CODE AND TROUBLESHOOTING
8 - 39
[E065] Incorrect paper size setting for bypass tray
[E090] Image data delay jam
Classification Error item
Other paper jam The size of paper in the 1st drawer differs from size setting of the
equipment.(E061)
The size of paper in the 2nd drawer differs from size setting of the
equipment.(E062)
The size of paper in the 3rd drawer differs from size setting of the
equipment.(E063)
The size of paper in the 4th drawer differs from size setting of the
equipment.(E064)
The size of paper in the bypass tray differs from size setting of the
equipment.(E065)
Check item Measures
Setting • If any paper remains in the equipment or drawer, remove it. Match the
paper size of the drawer setting and the one in the drawer.
• Paper size detection is performed at the first sheet of paper when the
drawer is opened or closed, or when the power of the equipment is
turned ON.
Replace parts Remarks
Classification Error item
Other paper jam Image data to be printed cannot be prepared.
Check item Measures
Other • Remove the paper remained in front of the registration sensor.
• If the error still occurs, check the following.
Power • Check if the error is cleared by turning the power OFF and then back
ON.
SYS board • Connector check
• Page memory check
• Board check.
SLG board • Connector check
• Harness check.
• Board check.
HDD
• Harness check.
Replace parts Remarks
Page memory
HDD
SYS board
SLG board