Toshiba e-STUDIO556 - System List

2
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
SPECIFICATIONS/ACCESSORIES/OPTIONS/SUPPLIES
2 - 17
2.3 System List
Fig. 2-1
* The finisher (MJ-1027/1028/1029) is necessary for the installation of the hole punch unit (MJ-
6003N/E/F/S) and the inserter (MJ-7001).
* The Printer kit (GM-1250), Printer/Scanner kit (GM-2270) and Scanner kit (GM-4250) are optional
for TWD/SAD/ASD/AUD model.
* The antenna (GN-3010) is necessary to enable the wireless LAN module (GN-1060).
* Up to 2 antennas (GN-3010) can be connected to the wireless LAN module (GN-1060).
* When the wireless LAN module (GN-1060) is installed, antenna (GN-3010) can be connected.
Staple cartridge
STAPLE-700
Staple cartridge
STAPLE-600
Staple cartridge
STAPLE-1700 STAPLE-1800 STAPLE-1900
Finisher
MJ-1027
Inserter
MJ-7001
2nd line for
Fax unit
GD-1260
NA/EU/AU/TW/C
Finisher
guide rail
KN-1017
Fax unit
GD-1250
NX/NA/EU/AU/
AS/TW/C
Damp heater
MF-6560U/E
Hole punch
unit
MJ-6003N/E/F/S
Saddle stitch finisher
MJ-1028
Saddle stitch finisher
MJ-1029
Antenna
GN-3010/C
Wireless LAN
module
GN-1060/C
LCF
MP-4004A
Scanner kit
GM-4250
Meta scan
enabler
GS-1010
External
interface enabler
GS-1020
IPsec enabler
GP-1080
Printer kit
GM-1250/C
Data
overwrite enabler
GP-1070
Printer/
Scanner kit
GM-2270
e-BRIDGE
ID Gate
KP-2005/C
e-BRIDGE
ID Gate
KP-2004
Unicode Font
Enabler
GS-1007
Harness kit
for coin controller
GQ-1240
Finisher guide rail
KN-1017
Operator's
manual pocket
KK-8560/C
Receiving tray
KA-8560/C