Toshiba e-STUDIO556 - Adjustment of the Paper Feeding System

6
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
ADJUSTMENT
6 - 55
6.10 Adjustment of the Paper Feeding System
6.10.1 Sheet sideways deviation caused by paper feeding
<Procedure>
The center of the printed image shifts to the front
side. -> Move the guide to the front side when
feeding paper from the bypass tray or the drawer.
Move the front cover to the rear side when
feeding paper from the Tandem LCF. (Arrow (A)
direction in the lower figure).
The center of the printed image shifts to the rear
side. -> Move the guide to the rear side when
feeding paper from the bypass tray or the drawer.
Move the front cover to the front side when
feeding paper from the Tandem LCF. (Arrow (B)
direction in the lower figure).
Fig. 6-43
Fig. 6-44
Bypass feeding
1. Loosen the screen.
2. Move the entire guide to the front or rear side.
3. Tighten the screw.
Drawer feeding
1. Loosen 2 screws.
2. Move the entire guide to the front or rear side.
3. Tighten the screws.
Fig. 6-45
Fig. 6-46
Feeding direction
Center
[
Rear
]
[
Front
]
Feeding direction
Center
[
Rear
]
[
Front
]
(
A
)(
B
)
(
B
)
(
A
)