Toshiba e-STUDIO556 - Registration Roller Unit

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 46
4.5.7 Registration roller unit
[ 1 ] Registration roller (rubber)
(1) Take off the cleaner unit.
(2) Remove 1 screw and take off the fixing
bracket.
(3) Open the right center cover and disconnect 1
connector.
(4) Pull out the registration roller unit toward the
front side while tilting it.
Fig. 4-130
(1) Remove 2 screws and take off the paper
guide.
(2) Remove 1 screw and take off the plate
spring.
Fig. 4-131
(3) Remove 1 clip and 2 springs.
Fig. 4-132
Registration roller unit
Fixing bracket
Paper guide
Plate spring
Spring
Clip