Toshiba e-STUDIO556 - RADF Board (RADF)

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 160
4.12.53 RADF board (RADF)
4.12.54 RADF board bracket
(1) Take off the RADF rear cover.
( P.4-117 "4.12.3 RADF rear cover")
(2) Remove 1 screw and take off the bracket[1].
Fig. 4-456
(3) Take off the RADF rear cover.
( P.4-117 "4.12.3 RADF rear cover")
(4) Disconnect 11 connectors. Remove 4 screws
and take off the RADF board.
Note:
When replacing the RADF board, be sure to
perform the original reading start sensor
adjustment.
( P.6-80 "6.14.8 Original reading start
sensor adjustment")
Fig. 4-457
(1) Take off the RADF rear cover.
( P.4-117 "4.12.3 RADF rear cover")
(2) Disconnect 11 connectors.
Fig. 4-458
[1]
LED3
LED3