Toshiba e-STUDIO556 - Reading Start Roller

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 131
4.12.18 Reading start roller
(4) Remove 1 E-ring and 1 bushing (front side).
Slide the intermediate transport roller,
remove 1 pulley and 1 bushing, and take off
the intermediate transport roller.
Note:
When installing the intermediate transport
roller, refix the loosened screw and tighten
the belt tension.
Fig. 4-371
(1) Take off the reading start guide unit.
( P.4-122 "4.12.10 Reading start guide
unit")
(2) Loosen 1 screw.
Fig. 4-372
(3) Remove 1 screw. Remove 1 timing belt, 1
pulley and 1 bearing.
Fig. 4-373
Bushing
E-ring
Bushing
Pulley
Intermediate transport roller
Bearing
Pulley