Toshiba e-STUDIO556 - Fuser Roller

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 104
4.10.8 Fuser roller
(1) Take off the fuser unit.
( P.4-96 "4.10.2 Fuser unit")
(2) Take off the cleaning web unit.
( P.4-97 "4.10.3 Cleaning web unit /
Cleaning web")
(3) Loosen 2 pressure screws completely.
Fig. 4-290
(4) Remove 2 screws and take off the fuser unit
cover (rear).
(5) Open the lower separation finger unit.
( P.4-102 "4.10.6 Lower separation finger
unit / Lower separation finger")
(6) Remove 2 screws and open the entrance
guide unit.
Fig. 4-291
(7) Remove 2 screws, release 2 harness clamp
and take off the bracket with releasing the
catching section.
Fig. 4-292
Pressure screw
Fuser unit cover
(
rear
)
Screw
Entrance guide unit
Harness clamp
Bracket
Screw
Screw