Toshiba e-STUDIO556 - Page 249

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 103
(4) Remove 2 screws and take off the stay.
Fig. 4-287
(5) Disconnect each connector, remove each
screw and take off the thermistor and
thermostat.
Fig. 4-288
Notes:
1. When installing the thermostats, be
careful not to deform the thermostats and
their brackets.
2. Adjust the gap between each thermostat
and the fuser roller to be 2.0-2.5 mm.
3. When installing, make sure that the
thermistor is in touch with the fuser roller.
Fig. 4-289
StayScrew Screw
Thermostat ThermistorThermistor
Screw
Screw
Screw
Heat roller
Thermostat
2.0~2.5mm
2.0~2.5mm