Toshiba e-STUDIO556 - Intermediate Transport Unit

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 36
4.5.2 Intermediate transport unit
[ 1 ] Motor driving PC board (MOT2-MT)
(1) Take off the first paper feeder unit.
( P.4-31 "4.5.1 Paper feeder unit / Bypass
feed unit")
(2) Disconnect 1 connector and remove 3
screws to take off the intermediate transport
unit.
Fig. 4-101
(1) Release the harness from the harness
clamp. Then remove 2 screws to take off the
bracket.
Note:
Be careful not to drop the gear because it will
comes out of place when its bracket is taken
off.
Fig. 4-102
(2) Remove 1 screw on the varistor.
(3) Removing 4 screws and 4 bushings to take
off the paper guide.
Fig. 4-103
Intermediate transport unit
Bracket
Gear
Gear
Varistor
Paper guide