Toshiba e-STUDIO556 - SLG Board Cooling Fan (M23)

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 12
4.3.3 SLG board cooling fan (M23)
4.3.4 Automatic original detection sensor (APS sensor) (S1 / S2 / S3 /
S4 / S5)
(3) Remove 5 screws to take off the lens cover
[1].
Fig. 4-31
(1) Take off the lens cover.
( P.4-11 "4.3.2 Lens cover")
(2) Disconnect 1 connector and remove 2
screws to take off the SLG board cooling fan.
Fig. 4-32
(1) Take off the lens cover.
( P.4-11 "4.3.2 Lens cover")
(2) Disconnect 1 connector, remove 1 screw and
take off the APS sensor.
Fig. 4-33
[1]
SLG board cooling fan