6
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
ADJUSTMENT
6 - 31
6.5 Image Quality Adjustment (Printing Function)
6.5.1 Adjustment of smudged/faint text
The smudged/faint text can be set at the following codes.
< Adjustment Mode (05) >
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in a code and press the [START] button.
(3) Key in an adjustment value.
(To correct the keyed-in value, press the [C] button.)
(4) Press the [OK] or [INTERRUPT] button to store the value. The equipment goes back to the ready
state.
(5) Shut down (turn the power OFF), back ON, and then perform the printing job.
(6) If the desired text density has not been attained, repeat step (2) to (5).
Language
Remarks
PS PCL XPS
7325 7326 7327 When the value increases, the smudged text is improved. When the value
decreases, the faint text is improved.
Acceptable values: 0 to 9 (Default: 5)
To Next Page
Loading...
