13
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
External Counters
13 - 1
13. External Counters
13.1 Outline
This specification describes the interface between external counters, such as Coin Controller and Key
Counter.
13.2 Signal
13.2.1 Pin Layout
1. Connector on the LGC board: CN343 (Coin Controller / Card Controller)
Pin
No.
I/O
Signal
name
Function Voltage level Remarks
GQ-
1240
GQ-
1050
GQ-
1060
1 Power +24VB 24V line DC24V±10% When cover
opened:
OFF
In use In use In use
2 Out TORON Total Counter On
Signal
Open Collector
(IC54)
L: ON In use In use In use
3 In KCTRC Copy permission
Signal 1
L=0V, H=DC5V
(IC56)
L: Allowed - - -
4 Out MCRUN Ready to Copy Signal Open Collector
(IC70)
L:
Operating
In use In use -
5 Out EXTCTR Exit Sensor On Signal Open Collector
(IC70)
L: ON In use - -
6 GND DG Power ground 0V In use - -
7 Out BKCTR Drawer feed Counter
Signal
Open Collector
(IC70)
L: ON - In use -
8 Out MNCTR ADU feed mode
Counter Signal
Open Collector
(IC70)
L: ON - In use -
9 GND SG Signal ground 0V - In use In use
10 Out SIZE0 Paper size Signal Open Collector
(IC70)
L: ON - In use -
11 Out SIZE1 Paper size Signal Open Collector
(IC70)
L: ON - In use -
12 Out SIZE2 Paper size Signal Open Collector
(IC13)
L: ON - In use -
13 Out SIZE3 Paper size Signal Open Collector
(IC13)
L: ON - In use -
14 Power VDD 5V line DC5V±3% At the sleep
mode:OFF
In use In use In use
15 In CTRCN2 Counter connection
Signal 2
L=0V, H=DC5V L:
Connecting
In use In use In use
To Next Page
Loading...
